SERIE JET, TREUIL 3/4 TONNE (SANS CABLE) USAGE INTENSIF

Compact high strength steel housing

Lightweight, simple and safe to operate

May be used in any position to lift, pull, lower or stretch heavy loads

The rope clamp system is easily disengaged with a lever, allowing smooth installation of the wire rope

Overload protection is built-in with a shear pin in the forward lever, which will break when overloaded

The design enables wire rope to be fed through 2 sets of wear-resistant interlocking jaws by a single operating lever

The SGP wire rope pulling hoist has a parallel clamping system, which has a large surface contact area, providing an evenly distributed grip at a lower force that results in less rope wear and maximum safety

All SGP wire rope pulling hoists are tested and have individual serial numbers for easy traceability to a test certificate (included)

Uses standard ASA and IWRC wire rope (not included)

The broken pins can be replaced without removing the load and spare shear pins are conveniently located in the rubber sleeve of the telescopic handle for SGP-75A and in the carrying handle for the SGP-150A and SGP-300A